Extreme Networks Universal Compute Platform Appliance 4120C Installation Manual page 17

Initial Network Connection and Configuration
•
DNS Settings
•
Data Plane Settings
5. At the end of each session, if you type Yes, the next session will begin. If you answer No, the session
configuration is repeated.
6. Press Enter.
After the final session is applied, the Post Installation Configuration menu opens.
7. Type A to apply settings and exit or a number for repeating the setup.
8. Connect to a port on which management access was enabled during the CLI Wizard Setup.
9. Open a web browser and, in the browser address bar, type: https://
Your_Mgmt_Ipaddress:5825.
The Extreme Universal Compute Platform's login screen is displayed. Refer to the Extreme Universal
Compute Platform Deployment Guide for more information.
10. Type the admin and password information that were created when setting up the installation wizard.
Note
The system's default gateway must be pointing to a next hop connective via the service
ports.
Note
An installation wizard is available to help configure the 4120C for new deployments. Refer
to the Extreme Universal Compute Platform Deployment Guide for more information.
Extreme Networks Universal Compute Platform Appliance 4120C 17