Replacing The Cover; Replacing The Cover - Epson Equity III User Manual

Replacing the Cover

After you install (or remove) an option card, follow these steps to replace
the main unit's cover:
1. With the front of the computer facing you, position the cover on the
computer as shown in Figure 4-8.
2. Pull the sides outward slightly and guide the curved edge on the bottom
of the cover underneath the ledge on the bottom of the computer.
3. Lower the cover over the computer and slide it straight back until the
front panel is flush with the diskette drive and key lock.
4. To secure the cover, replace the four screws on the back panel.
5. Return the main unit to its original position and place the monitor on
top, if that is where you keep it. Then reconnect the main unit to the
monitor, the keyboard, and any other peripherals you have.
6. Check to be sure the power switch on the main unit is off. Then recon-
nect the power cable to the back of the main unit and to an electrical
outlet.
Figure 4-8. Replacing the cover
4-7