Replacing The Cover; Using An Epson Mouse - Epson Equity III User Manual

Replacing the Cover

After you install (or remove) an option card or change DIP switch
settings, follow these steps to replace the main unit's cover:
Position the cover on the computer so you leave enough space to slide
1.
it back into place.
Slide the cover into place so the metal tabs go underneath the top edge
2.
of the front panel.
To secure the cover, replace the two screws on either side of the main
3.
unit.
Turn the main unit around so the front faces you and place the moni-
4.
tor back on top, if that is where you keep it. Then reconnect the main
unit to the monitor, the keyboard, and any other peripherals you
have.
Check to be sure the power switch on the main unit is off. Then recon-
5.
nect the power cable to the back of the main unit and to an electrical
outlet.

Using an Epson Mouse

You can use the Epson mouse with special software to enter data and
direct a pointer on the screen. For example, you can point to an instruc-
tion on the screen and press a button on the mouse to perform the com-
mand. Refer to the software manual that comes with the mouse, or the
application program, for instructions on how to use it.
If you need to install an option card to use the mouse, follow the
instructions in this chapter to install it. Then connect the mouse's cable to
the connector on the card. If your mouse does not require a card, connect
the cable to the serial port on the rear panel.
To use the mouse, remove the velcro strip that covers the roller.
When you are not using it, replace the velcro strip to keep out dust and
dirt. Use the mouse only on a hard, flat surface, never on carpet-like
material or on a wet surface.
42