Removing Circuit Board Screws; Unplugging Connector Cn6 From Hard Disk Controller Card - Epson Equity III User Manual

Figure A-5. Removing circuit board screws
3. The small circuit board (on the front of the computer), which contains
the power and hard disk LEDs, is connected to the hard disk controller
card by a black and red twisted cable. Unplug the connector from the
hard disk controller card-the connector is labeled CN6 on the card-
as shown in Figure A-6, and lay the cable to one side.
Figure A-6. Unplugging connector CN6 from hard disk controller card
A-6