Installing A 3.5-Inch Drive - Epson Endeavor P60 User Manual

Installing a 3.5-inch Drive

Follow these steps to install a drive in the 3.5-inch drive carrier:
1. Follow the instructions on page 5-4 to remove the drive
carrier from the computer.
Position the drive so its front panel faces the front of the
2.
drive carrier and the drive's connectors face the back. Then
slide the drive into the carrier.
Install the four screws that came with the drive to secure it
3.
to the drive carrier. If you are installing a drive in the lower
drive carrier bay, you can install the screws on the bottom
of the carrier or at the sides.
Follow the instructions on page 5-6 to reinstall the drive
4.
carrier in the computer.
Installing and Removing Drives
5-7