On-Board Ide Drive; First Serial Port Address; Second Serial Port Address; Parallel Port Address - Epson Endeavor P60 User Manual

On-board IDE Drive

This option allows you to enable or disable the built-in IDE
hard disk drive controller. The default setting is Enabled.

First Serial Port Address

You can select a COMl address of 2E8H, 3E8H, 2F8H, or 3F8H.
If Programming Option is set to Auto, this option is set to
Disabled.

Second Serial Port Address

You can select a COM2 address of 2ESH, 3ESH, 2FSH, or 3FSH.
If Programming Option is set to Auto, this option is set to
Disabled.

Parallel Port Address

You can select an address of 278H, 378H, or 3BCH. If
Programming Option is set to Auto,
Disabled.

IRQ Active State

This option allows you to set the IRQ signal High or Low to
assert the interrupt. The default setting is High.

Parallel Port Mode

This option sets the mode used by the built-in parallel port.
You can select Normal or Extended (or EPP, enhanced
bidirectional parallel port, for higher performance when you
use an EPP device). The default setting is Normal.
2-12 Running the Setup Program
this option is set to