Table of Contents
Advertisement
Configure With BIOS Defaults
This option loads the CMOS with the default values contained
in the flash ROM.
Configure With Power- on Defaults
This option reloads the CMOS with the values stored at the last
power-on of the system.
Change Password
When you set a password with this option, you enable the
system password function. The password prevents
unauthorized users from accessing the Setup program or
from booting the operating system.
You can enter a password of up to six characters. Setup
prompts you to enter the password twice; then you see the
message, Password Now Enabled. Press ESC
You can also change or delete the password with this option:
if necessary. To delete the password and disable password
checking, enter the current password at the first prompt and
then press Enter when Setup prompts you to enter a new
password.
If you forget your password, you must change the setting
of a jumper on the main system board. See Chapter 4 for
instructions.
Running the Setup Program
to exit.
2 - 1 3
Advertisement
Table of Contents
Troubleshooting
