Selecting The Security Setup Options - Epson ActionTower 8000 User Manual

The table below describes the available options
Boot sequence option settings
Option
A: then C: *
C: then A:
C: only
* Default setting
N o t e
If you set Boot sequence to C: only, you will not be
able to start your system when there is a problem with your
hard disk drive.
If you set the Boot sequence option to C: only, you
should disable the Floppy check option so the system
doesn't access the diskette drive during the startup procedure.
Disabling this option decreases the time needed to start the
system; the default setting is Enabled.

Selecting the Security Setup Options

W h e n y o u s e l e c t S e c u r i t y S e t u p f r o m t h e M a i n M e n u ,
you see the Security Setup screen, which contains options that
allow you to set passwords and other security and anti-virus
options, as described below.
Description
Loads operating system from drive A; if it isn't
there, loads it from drive C (recommended
setting)
Loads operating system from drive C; if it isn't
there, loads it from drive A
Loads operating system from drive C
Running SETUP and Installing Drivers
2 - 1 3