Epson PhotoPC 850Z User Manual page 16

2
Connect the battery charger to its power cord, as shown
below.
charger light
3
Plug the charger into an electrical outlet. The charger
light turns red, indicating that the charger is working.
When the batteries are charged, after about two and a
half hours, the light goes off.
NOTE
The charger light flashes to indicate changes in battery
temperature and voltage. If the light continues to flash for
more than half an hour, the batteries may be damaged or
worn out, and should be replaced. Unplug the charger if the
batteries are not fully charged after four hours.
4
Now charge your batteries again by unplugging the
battery power cord and then plugging it in again.
5
Charge the batteries a third time. After the charger light
goes off, unplug the charger. To avoid overcharging,
don't leave the charger plugged in for long periods of
time after the light goes off.
6
Wait one hour until the batteries cool before removing
them from the charger.
WARNING
Batteries are very hot (149 °F [65 °C]) after charging.
7
Before storing the charger, disconnect the power cord
and remove the batteries.
(For subsequent charges of your NiMH rechargeable
batteries, follow steps 1 through 3, then unplug the charger
and follow steps 6 and 7 above.)
Setting Up Your Camera and Software 1-3
1
A
B