Setting Up In Lasercad (Hp Machines) - BOSSLASER BossMod LS User Manual & Setup Manual

BOSSMOD USER MANUAL & SETUP FOR LS & HP MACHINES
On the AWC Control Panel, press the Menu button, then go to:
7. Common Parameter Settings > Press Enter > 4. Rotate Engraving&Cutting > Press Enter
The following picture shows that four parameters that need to be adjusted in order to use the
BossMod.
To use the Chuck Rotary of the BossMod:
• Rotate Fun – Open
• Rotate Axis – Y
• Pulse Count Per Rotate – 010000 (10,000)
• Current Diameter (mm) – Input the diameter of the engraving surface (not where it is
clamped)
To use the Roller Rotary of the BossMod:
• Rotate Fun – Open
• Rotate Axis – Y
• Pulse Count Per Rotate – 010000 (10,000)
• Current Diameter (mm) – 066.0 (66 mm)
✎NOTE: You will need to RESET the machine (Turning off/on the machine or pressing the
To go back to the worktable, change the Rotate Fun to "Close," then press the Enter button.
Document Number: QM – 855-914

Setting up in LaserCAD (HP Machines)

RESET button) after you've made changes!
Then RESET the machine to save changes to the machine.
Revision Number: 001 Revision Date: 11/1/2019 BOSSLASER - Page 14 of 18