Table of Contents
Advertisement
BOSSMOD USER MANUAL & SETUP FOR LS & HP MACHINES
Setting Up the BossMod on the Machine
There will two rotary brackets located inside the worktable. You will need to remove the knife
blades from the worktable to be able to gain access to these rotary brackets. Here, you can
place the BossMod on the rotary brackets with the motor side facing the right side of the
as shown below).
worktable (
: Make sure the machine is off before continuing
⚠IMPORTANT
To install the BossMod to the machine, locate the Y-Axis 4-pin connector towards the back
(inside), middle of the machine. There, you will find the Y-Axis motor connected to a 4-pin plug.
Unplug this existing 4-pin connector and plug in the 4-pin connector from the BossMod (as
shown below):
When you are done using the BossMod, unplug the 4-pin connector for the
rotary device and plug back in the original 4-pin connector for the Y-Axis Motor.
Document Number: QM – 855-914
Revision Number: 001 Revision Date: 11/1/2019
BOSSLASER - Page 8 of 18
Advertisement
Table of Contents
