Table of Contents
Advertisement
BOSSMOD USER MANUAL & SETUP FOR LS & HP MACHINES
2. Accessory Platform
The accessory platform was designed to accommodate several different attachments that
would suit different applications. The intent was to also allow the end-user to retrofit,
customer-made attachments for custom applications. These attachments can be replaced very
easily and rapidly.
As you can see from the picture above, the plate was specifically pre-tapped in multiple
locations to allow for all sorts of attachments. This platform is also mounted on precision sliding
rails allowing to adjust for various length of objects.
3. Chuck Mount
The chuck mount is the piece located behind the chuck head and holds the chuck head in place.
There are two different hole patterns built in the chuck mount. This was designed to
accommodate various types of chuck heads. It is now possible to change your chuck head easily
to fit different applications better.
Document Number: QM – 855-914
Revision Number: 001 Revision Date: 11/1/2019
BOSSLASER - Page 3 of 18
Advertisement
Table of Contents
