Advertisement
Quick Links
IBDM208
Issue 2 16/06/2000
ECR 972
BDM 208 & BDM216
Operating Instructions
Baldwin Boxall Communications Ltd.
Wealden Industrial Estate, Farningham Road
Crowborough, East Sussex, TN6 2JR
Telephone: 01892 664422 Fax: 01892 663146
Website: www.baldwinboxall.co.uk
Email: mail@baldwinboxall.co.uk
Advertisement
Related Manuals for Baldwin Boxall BDM 208
Summary of Contents for Baldwin Boxall BDM 208
- Page 1 IBDM208 Issue 2 16/06/2000 ECR 972 BDM 208 & BDM216 Operating Instructions Baldwin Boxall Communications Ltd. Wealden Industrial Estate, Farningham Road Crowborough, East Sussex, TN6 2JR Telephone: 01892 664422 Fax: 01892 663146 Website: www.baldwinboxall.co.uk Email: mail@baldwinboxall.co.uk...
- Page 2 BDM 208 and BDM 216 The BDM 208 and 216 dynamic microphones are designed for use with our MITRE, ADEPT and VIGIL amplifiers. To Operate Select zones needed. An LED will illuminate indicating selected zone. Press ‘Speak’ and make the announcement. If a pre-announcement chime is being used, the ‘Speak Now’...
-
Page 3: Technical Specification
Bass Cut Bass cut operating at 350Hz is selectable if required. This can be particularly advantageous to overcome the affects of talking closely to the microphone. Limiter Selecting the limiter will ensure that the signal level remains fairly constant irrespective of input level changes. Using it will prevent system overload when different personnel use the microphone or speak too close to the microphone. - Page 4 Figure 2. BDM 208 & 216 Selector Locations (on base) and Settings Preset Output Level Indicator (no access from base - on PCB) Holes in base to allow switch selection 1 2 3 4 SPEAK NOW INDICATOR BASS CUT Instant - no delay...
- Page 5 Figure 4. To remove the base Ensure that the supply is disconnected. To remove the base, remove the 2 lower screws from both the left and right hand sides. Carefully lift the top, including the side panels, away from the base. Cable removal from Base Remove nut from gland.