Table of Contents
Advertisement
Layering and Splitting Tones
You can configure the keyboard to play two different tones at the same time (Layer) or to play different
tones in the left and right ranges (Split). You can even use Layer and Split in combination with each
other and play three different tones at the same time.
The part that is used when playing a single tone is called the UPPER1 part. If you layer two parts, the
layered part is the UPPER2 part. If the keyboard is split between two tones, the low-range part is called
the LOWER part.
• Sounding a single tone across the entire keyboard (page EN-68)
With this configuration, only the UPPER1 part is used (Layer: Off, Split: Off).
• Layering two tones across the entire keyboard (page EN-125)
With this configuration, the UPPER1 and UPPER2 parts are both used (Layer: On, Split: Off).
• Splitting the keyboard into two ranges (left, right), and assigning different tones to each range
(page EN-126)
With this configuration, the UPPER1 part and LOWER part are both used (Layer: Off, Split: On).
UPPER1
UPPER2
LOWER
EN-123
Controlling the Sound of a Performance
UPPER1
UPPER1
Advertisement
Table of Contents
