Epson BrightLink Solo Interactive Module IU-01 User Manual page 17

Calibrating
c
Wait until you see a flashing green circle in the upper left corner
of your projected image.
d
Touch the center of the circle with the tip of the pen.
The circle stops flashing and turns black. You see another circle on
the right.
e
Touch the center of the next circle, then repeat. When you get to
the end of the row, the next circle appears at the left edge of a
new row.
a
• For the most accurate calibration, make sure you hold the pen
at an angle to the projection surface and touch the center of
the circle.
• Make sure you are not blocking the signal between the pen
and the interactive receiver.
• Don't press the button on the side of the pen while
calibrating.
• If you make a mistake or want to stop calibrating, press [Esc]
on your computer keyboard. Then restart the calibration
process as described above.
f
Continue until all of the circles are black.
17