Hoover HT6360IN/1 Instruction Manual page 10

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
will void manufactures warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by
hand. Soak them for about 3 minute in
water with a grease-loosening
detergent then brush it gently with a
soft brush. Please do not apply too
much pressure, avoid to damage it .
(Leave to dry naturally out of direct
sun light)
Filters should be washed separately to crockery and kitchen utensils. it is advisable
not to use rinse aid.
INSTALLING GREASE MESH FILTERS
• To install filters for the following four steps .
- Angle the filter into slots at the back of the hood.
- Push the button on handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed at three or six months according to your cooking habit. The
installation procedure of activated carbon filter is as below.
 Please pull out the hood and take off the tow filters.
 Fix the charcoal filter into motor side to make sure its tighten.See Pic.below.
 Put back the two filters into hood.
NOTE:
 Make sure the filter is securely locked. Otherwise, it would loosen and cause
dangerous.
 When activated carbon filter attached, the suction power will be lowered.
10

Advertisement

Table of Contents
loading

Table of Contents