Table of Contents
Related Manuals for Edwards M528-09-160
Summary of Contents for Edwards M528-09-160
- Page 1 M528-01-860 Issue A Original Instruction Manual CXS Inlet/Exhaust Temperature Indicator Accessory Kits Description Item Number Inlet Temperature Indicator Accessory Kit M528-09-160 Exhaust Temperature Indicator Accessory Kit M528-09-170...
- Page 2 This page has been intentionally left blank.
-
Page 3: Table Of Contents
CXS Pumping System Instruction Manual M528-00-880 WIKA operating instructions Models 53, 54, 55 (ATEX) Trademark credits ® Loctite is a registered trademark of Henkel Corporation © Edwards Limited 2013. All rights reserved. Page i Edwards and the Edwards logo are trademarks of Edwards Limited. - Page 4 M528-01-860 Issue A This page has been intentionally left blank. Page ii © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited.
-
Page 5: Introduction
Quantity Temperature Gauge -20°C to 200°C Instruction Manual Bimetal Thermometer Operating instructions The Exhaust pressure indicator assembly is supplied fully assembled © Edwards Limited 2013. All rights reserved. Page 1 Edwards and the Edwards logo are trademarks of Edwards Limited. - Page 6 M528-01-860 Issue A This page has been intentionally left blank. Page 2 © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited.
-
Page 7: Installation
Particular caution should be exercised when working with fluorinated materials which may have been exposed to temperatures greater than 260°C. Refer to Edwards Material Safety Data Sheets for detailed information. -
Page 8: Inlet Temperature Indicator Mounting Port Position
Figure 1 - Inlet Temperature Indicator Mounting Port Position Remove 1/2” BSP blanking plug Figure 2 - Inlet Temperature Indicator Mounting Position Page 4 © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited. -
Page 9: Installing The Exhaust Temperature Indicator Assembly
5. Leak test the exhaust temperature indicator assembly and seal any leaks found. Figure 3 - Exhaust Temperature Indicator Mounting Port Position Remove 1/2” BSP blanking plug © Edwards Limited 2013. All rights reserved. Page 5 Edwards and the Edwards logo are trademarks of Edwards Limited. -
Page 10: Exhaust Temperature Indicator Mounting Position
M528-01-860 Issue A Figure 4 - Exhaust Temperature Indicator Mounting Position Page 6 © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited. -
Page 11: Operation And Maintenance
Please refer to the CXS pumping system and temperature gauge instruction manuals for operating instructions. There is no requirement for routine maintenance of the inlet/exhaust temperature indicator assemblies. © Edwards Limited 2013. All rights reserved. Page 7 Edwards and the Edwards logo are trademarks of Edwards Limited. - Page 12 M528-01-860 Issue A This page has been intentionally left blank. Page 8 © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited.
- Page 13 This page has been intentionally left blank.
- Page 14 This page has been intentionally left blank.
- Page 15 Download the latest documents from www.edwardsvacuum.com/HSForms/, follow the procedure in HS1, fill in the electronic HS2 form, print it, sign it, and return the signed copy to Edwards. Note: If we do not receive a completed HS2 form, we will not accept the return of the...
- Page 16 edwardsvacuum.com...
Need help?
Do you have a question about the M528-09-160 and is the answer not in the manual?
Questions and answers