LENCO LBT-225 User Manual page 8

Note:
• If the Phono/Line switch is set at LINE position but RCA jacks connected to the stereo system's phono input, the
sound might be distorted due to input overload and could damage your stereo system.
• If the Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo system's line input,
the volume will be very low due to lacking signal pre-amplification.
RCA Jack is not designed to be connected directly to the passive/unpowered speakers and if it does, the volume
will be very low.
GAIN SELECT switch
When playing, adjust the difference of the volume of the vinyl records. If the audio track was recorded on the vinyl
record at a quite volume, set this to HIGH to play at the appropriate volume. If the audio track was recorded on
the vinyl record at a loud volume, the sound may become distorted if you play the vinyl record with this set to
HIGH. Change the settings to be appropriate for the vinyl record.
Volume adjustment is effective for audio output when the OUTPUT SELECT switch is set to LINE, the playback
volume on BLUETOOTH connections, and the recording volume on the computer. It is ineffective for audio output
when the OUTPUT SELECT switch is set to PHONO.
Main Power Connection
The power adaptor is in the foam packing material. Unpack the power adaptor and plug the small end into the DC
power jack located at the back side of the turntable. Plug the power adaptor into your power outlet.
Operation
Turntable Operation
1. Connect the included power adapter to unit and Press the power button to power ON the turntable.
2. Remove the needle cover from the cartridge.
3. Place the slipmat on the platter and place a record on the slipmat. If using 45 RPM records, put the 45 RPM
adapter on the center spindle before placing the record on the platter.
4. Set the 33/45 RPM Selector according to the type of record.
5. Unlock the arm clip and set the Lift Lever to the up position.
6. Position the tonearm over the desired location (groove) on the record.
7. Move the tonearm lift lever to the down position to move the tonearm toward the record. Alternatively, place
the needle over the desired location on the record.
8. Carefully lower the tonearm on the record.
9. When you are finished playing the record, raise the tonearm, return it to rest on the arm clip, and turn the
Speed/Stop Knob to the Stop.
10. Press the power button to turn off the power.
Bluetooth Operation
This unit has a Bluetooth transmitter to send the sound to a Bluetooth speaker or headphone wirelessly.
1. Power on your Bluetooth speaker and ensure it is in pairing mode.
2. Power ON the turntable with the power button. The LED indicator will first light to RED and then will flash in
blue during Bluetooth searching of the external speaker or headphone.
Note: if you want to disable the Bluetooth searching function you can press the Power button for 3 seconds,
then the Led light indicator will light to RED.
The platter starts to spinning.
- 8 -