Table of Contents
Advertisement
Available languages
Available languages
Product Description
Stepped Drive Pulley
Drive Belt
Turntable Spindle
Turntable Hub
Turntable Platter
Speed/Stop Knob
Dust Cover
Ground Connector
R Jack for RCA Line out
L Jack for RCA Line out
Phono/Line Out Switch
Initial Setup
1.
Place the unit on a flat and level surface. The selected location should be stable and free from vibration.
2.
Install the turntable lid to the hinges.
3.
Remove the tie-wrap that is holding the tonearm.
4.
Put the drive belt around the Turntable Hub, and then use the provided belt hoot to help pull the belt to fit
around the slot of motor pulley.
5.
Place the turntable platter through the turntable spindle.
6.
Place the slip mat on top of the turntable platter.
Slide Tonearm Counterweight onto tonearm and twist it lightly onto the rear shaft of the tonearm.
7.
8.
Adjust the counterweight to set proper stylus pressure.
9.
Locate the anti-skating weight
10. Connect AC-DC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is completed.
Lid Hinge
Power Jack
USB-PC Jack
Gain Select
- 5 -
Anti-skating Weight
Power & Bluetooth indicator
Power button
Tonearm Counterweight
Anti-skating Stub
Tonearm Lift
Tonearm Lift Lever
Tonearm Clip
Removable Headshell with
Cartridge
Advertisement
Table of Contents
