Advertisement
To do this:
1. Stop the drill by taking your finger o the power trigger.
2. Switch the direction bu on into reverse then press the trigger until the drill bit is clear of the wood.
3. Use a brush to remove any scraps or dust from the drill bit. DO NOT use your fingers.
4. Switch the direction bu on into forward to continue drilling into piece of work.
NOTE: If you are drilling into a piece of wood that is likely to splinter you may want to use a 'back-up'
block of wood place behind the piece you are drilling.
You will drill a cleaner hole if you ease up on the pressure just before the bit breaks through the back of
the wood. Turn the wood over and complete the hole.
DRILLING METAL
There are two main things to remember when drilling through metal.
1. The harder the material, the greater the pressure you need to apply to the drill.
2. The harder the material, the slower the speed of the drill needs to be.
Below are a few tips to help when drilling through metal.
1. Lubricate the tip of the drill bit occasionally with cu ing oil except when drilling so metals such as
aluminium, copper or cast iron.
2. If the hole you wish to drill is quite large, drill a smaller hole first then enlarge to the final size. This is
generally a faster method in the long run.
3. Maintain enough pressure to assure that the drill bit does not just spin in the hole. This will make the
drill bit blunt and shorten its life.
6. BATTERY TECHNICAL SPECIFICATION
Ba ery pack 18 V DC 2000 mAh Li-ion ba ery pack
Charger adapter input 220-240 V AC 50-60 Hz
7. TECHNICAL SPECIFICATION
Power: 18 V
No-load speed: 0-400/0-1500 rpm
Max torque: 58 N.m
Clutch: 15+1 se ing
Chuck: 2-13 mm
11
Advertisement
