Advertisement
• Position the cord clear of rotating bit. Do not wrap the cord around your arm or wrist. If you lose
control and have the cord wrapped around your arm or wrist it may entrap you and cause injury.
• Position yourself to avoid being caught between the tool or side handle and walls or posts.
• Should the bit become bound or jammed in the work, the reaction torque of the tool could crush your
hand or leg.
• If the bit becomes bound in the work piece, release the trigger immediately, reverse the direction of
rotation and slowly squeeze the trigger to back out the bit. Be ready for a strong reaction torque. The
drill body will tend to twist in the opposite direction as the drill bit is rotating.
• Do not grasp the tool or place your hands too close to the spinning chuck or drill bit. Your hand may
be lacerated.
• When installing a drill bit, insert the shank of the bit well within the jaws of the chuck. If the bit is not
inserted deep enough, the grip of the jaws over the bit is reduced and the loss of control is increased.
• Do not use dull or damaged bits and accessories. Dull or damaged bits have a greater tendency to
bind in the work piece.
• When removing the bit from the tool avoid contact with skin and use proper protective gloves when
grasping the bit or accessory. Accessories may be hot a er prolonged use.
• Do not run the drill while carrying it at your side. A spinning drill bit could become entangled with
clothing and injury may result.
WE RECOMMEND THAT THE OPERATOR WEARS HEARING PROTECTION.
• The declared vibration total value has been measured in accordance with standard test method and
may be used for comparing one tool with another.
• The declared vibration total value may also be used in a preliminary assessment of exposure.
WARNING! The vibration emissions during actual use of the power tool can di er from the declared
total value depending on the ways in which the tool is used, and of the need to identify safety measu-
res to protect the operator that are based on an estimate of exposure in the actual conditions of use
(taking account of all parts of the operating cycle such as times when the tool is switched o and when
it is running idle in addition to trigger time).
LpA (acoustic pressure): 77.8dB(A) (KWA=3 dB)
Vibration: 0.670m/s (K=1.5m/s )
LwA (acoustic pressure): 88.8dB(A) (KWA=3 dB)
2. BATTERY WARNINGS
• Before using ba ery charger, read all instructions and caution marks on ba ery charger, ba ery pack,
and product using ba ery.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard.
• Use only the charger which accompanied your product or direct replacement as listed in the catalogue
or this manual. Do not substitute any other charger. Use only same supplier approved chargers with
your product.
SEE TECHNICAL SPECIFICATIONS
• Do not disassemble charger or operate the charger if it has received a sharp blow, been dropped or
otherwise damaged in any way. Incorrect reassembly may result in a risk of electric shock, electrocution
or fire.
• Do not recharge ba ery in damp or wet environment. Do not expose charger to rain or snow. If
ba ery case is cracked or otherwise damaged, do not insert into charger. Ba ery short or fire may
7
Advertisement
