Table of Contents
Advertisement
Drilling in metal
Vibration emission value at = 3.8 m/s2
K uncertainty = 1.5 m/s2
Screwing without hammer action
Vibration emission value at <2.5 m/s2
K uncertainty = 1.5 m/s2
Screwdriving
We recommend using self-centering screws (e.g. Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matchesthe screw in shape and size. Set the torque, as
described elsewhere in these operating instructions, to suit the size of screw.
7. TECHNICAL SPECIFICATIONS
Power: 20 V
No load speed: 0-400/0-1400 rpm
Clutch: 19+1 se ing
Max torque: 45 Nm
Chuck: 2-13 mm keyless
Charging time: 1 hour
Includes: 1 pc 2.0 Ah Ba ery and 1 pc Quick charger.
IMPORTANT! The vibration value changes according to the area, of application of the electric tool and
may exceed the specified value in exceptional circumstances.
Always pull out the mains power plug before starting any cleaning work.
8. CLEANING AND MAINTENANCE
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with compressed air at low pressure.
• We recommend that you clean the device immediately each time you have finished using it.
• Clean the equipment regularly with a moist cloth and some so soap. Do not use cleaning agents or
solvents; these could a ack the plastic parts of the equipment. Ensure that no water can seep into the
device.
Please charge the ba ery pack regularly, for example, once every 6 months.
Only use accessories and spare parts recommended by the manufacturer.
If the equipment should fail some day in spite of our quality controls and your maintenance,
only have it repaired by an authorized electrician.
9. ENVIRONMENTAL PROTECTION
End of life electrical equipment must not be placed in household waste. Please take it to a
return point. Find out about your nearest return point from your council or sales outlet.
10
Advertisement
Table of Contents
