Table of Contents
Advertisement
Loosen the clamp on the saddle seat post to release the seat post before adjusting the saddle height. You will find
a standard clamp or one built into the frame, depending on the bicycle model. In any case, respect the bolt tightening
torque specs to prevent the saddle from moving if it is too loose or from damaging the frame and seat post if it is
too tight. Check the tightening torques recommended by the manufacturers. BH indicates the necessary tightening
torques of each bicycle model in its specific manuals.
S TA N D A R D S E AT P O S T C L A M P
A D J U S T I N G T H E H E A D S E T
The bicycle's headset is designed to make the handlebars and fork turn with no resistance and smoothly. The example
in the image below shows that there are a series of bearings and washers to allow this. Gaps may appear between the
parts if these are not compressed correctly using a spindle or they are not maintained as needed. You can check for
gaps by moving the handlebars from side to side, listening for abnormal noises or clicks. If there are gaps, do not use
the bicycle and take it to your nearest official BH dealer.
In the case of bicycles with a built-in BH FIT stem, the spindle is replaced with a set of washers, built into the stem.
Refer to your bicycle's manual if the bicycle features a BH FIT stem to learn more about how it must be mounted correctly.
Riding a bicycle with gaps on its parts may result in a serious accident.
0 5 S E T T I N G S A N D S A F E T Y C H E C K S
E X A M P L E O F A H E A D S E T
A D J U S T I N G T H E S T E M , H A N D L E B A R S A N D L E V E R S
The handlebars are used to guide the entire bicycle. Therefore, in terms of safety, this is one of the most important
elements. To prevent unwanted maladjustments during the trip that may cause accidents, the parts must be mounted
with the tightening torque required by the manufacturers. The stem on the fork and handlebars. An excessively
high tightening torque may cause damage that is not covered by the warranty. Likewise, it is important to place the
derailleur and brake levers so that, in the normal pedalling position, they are within reach of the fingers.
Refer to your bicycle's manual if the bicycle features a BH FIT stem to learn more about how it must be mounted correctly.
G E N E R A L U S E R M A N U A L
BH
8
Advertisement
Table of Contents
