Load Paper; Connect The Phone Cord - Epson WorkForce 435 Quick Setup Instructions

4
Remove only the yellow tape from each cartridge.
Caution: Don't remove any other seals or the cartridges may
leak.
5
Insert the cartridges in the holder for each color.
6
Press each cartridge down until it clicks.
7
Close the cartridge cover. Press down until it clicks.
8
Lower the scanner.
9
Press the OK button to prime the printer.
Priming takes about 3 minutes.
Note: Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution: Don't turn off the printer while it is priming or you'll
waste ink.
5

Load paper

1
Open the paper support and pull up the extensions.
2
Pull out the output tray extensions and raise the stopper.
3
Squeeze the edge guide as you slide it all the way to the
left.
4
Load letter- or A4-size paper against the right edge and
behind the tab, with the printable side face up.
5
Slide the edge guide over.
6

Connect the phone cord

To fax, connect a phone cord to a telephone wall jack and
to the LINE port on your product. To connect a telephone or
answering machine, use the EXT. port on your product. See
the Quick Guide for more details.
Note: If you're connecting to a DSL phone line, you must use a DSL
filter or you won't be able to fax. Contact your DSL provider for the
necessary filter.