Load Paper - Epson Stylus Photo RX600 Start Here Manual

3
Open the cartridge cover by pulling it toward you.
4
Remove the ink cartridges from their packages.
Caution: You must install all the cartridges
and leave them installed for all types of printing.
To avoid damaging the RX600, never move the
print head by hand.
5
Lower each cartridge into the holder marked
with the corresponding color.
6
Press down on each cartridge until it clicks
into place. Then close the ink cartridge cover
until it clicks into place.
Caution: Don't force the cartridge cover
closed. If it doesn't close easily, open it and
make sure all the cartridges are firmly seated.
7
Lower the scanner unit.
The RX600 begins charging the ink
delivery system.
Charging takes about 2 minutes. Initial
charge appears on the RX600 screen.
Caution: Don't turn the RX600 off while
you see the Initial charge message or
you'll waste ink.
7

Load Paper

1
Insert the paper support into the two slots on the back of the RX600.
2
Open the output tray.
3
Flip the feeder guard forward.
4
Place a stack of paper in the top
of the RX600, between the edge
guides and beneath their tabs.
Then slide the left edge guide
against the paper, but not
too tightly.
5
Flip the feeder guard back over the
stack of paper.
Note: If you don't flip the feeder
guard back, your paper may jam.
Turn over