General Safety Instructions - NDS Dometic SCE320 Operating Manual

EN
Note Supplementary information for operating the product.

3 General safety instructions

Also observe the safety instructions and stipulations issued by the vehicle manufacturer and autho-
rized workshops.
WARNING! Electrocution hazard
Failure to obey these warnings could result in death or serious injury.
• Installation and removal of the battery charger may only be carried out by qualified personnel.
• Do not operate the device if it is visibly damaged.
• If this device's power cable is damaged, the power cable must be replaced by the manufacturer, a
service agent or a similarly qualified person in order to prevent safety hazards.
• This device may only be repaired by qualified personnel. Improper repairs can lead to considerable
hazards.
• If you disassemble the device: Detach all connections. Ensure that no voltage is present on any of
the inputs and outputs.
• Do not use the device in wet conditions or submerge in any liquid. Store in a dry place.
• Only use accessories that are recommended by the manufacturer.
• Do not modify or adapt any of the components in any way.
Disconnect the device from the power supply:
• Before each cleaning and maintenance
• After every use
• Before changing a fuse
• Before carrying out electrical welding work or work on the electrical system
WARNING! Health hazard
Failure to obey these warnings could result in death or serious injury.
• This device can be used by children aged from 8 years and above and persons with reduced physi-
cal, sensory or mental capabilities or lack of experience and know-ledge if they have been given su-
pervision or instruction concerning use of the device in a safe way and understand the hazards in-
volved.
• Electrical devices are not toys. Always keep and use the device out of the reach of very young
children.
• Children must be supervised to ensure that they do not play with the device.
• Cleaning and user maintenance shall not be made by children without supervision.
NOTICE! Damage hazard
• Before start-up, check that the voltage specification on the data plate is the same as that of the pow-
er supply.
• Ensure that other objects cannot cause a short circuit at the contacts of the device.
• Ensure that the negative and positive poles never come into contact.
4