EDIFIER R1080BT - Multimedia Speaker Manual

1. Please read the instructions carefully. Keep it in safe place for future reference.
2. Use only accessories approved by the manufacturer.
3. Install the instrument properly by following the instructions in the device connection section.
4. Using the product in a 0-35°C environment is recommended.
5. To reduce the risk of fire and electric shock, do not expose the product to rain or moisture.
6. Do not use this product near water. Do not immerge the product into any liquid or have it exposed to dripping or splashing.
7. Do not install or use this product near any heat source (e.g. radiator, heater, stove, or other devices that generate heat).
8. Do not place any object filled with liquids, such as vases on the product; neither should any open fire, such as lighted candles be placed on the product.
9. Do not block any ventilation openings. Do not insert any object into ventilation openings or slots. It may cause fire or electric shock.
10. Keep sufficient clearance around the product to maintain good ventilation (minimum 5cm is recommended).
11. Do not force a plug into the jack. Before connection, check for blockage in the jack and whether the plug matches the jack and is oriented to the right direction.
12. Keep the provided accessories and parts (such as screws) away from children to prevent from being swallowed by mistake.
13. Do not open or remove the housing yourself. It may expose you to dangerous voltage or other hazardous risks. Regardless the cause of damage (such as damaged wire or plug, exposure to liquid splash or foreign object falling in, exposure to rain or moisture, product not working or being dropped, etc.), the repair has to be performed by an authorized service professional immediately.
14. Before cleaning the product with dry cloth, always turn off the product and disconnect the power plug first.
15. Never use strong acid, alkali, gasoline, alcohol, or other chemical solvents to clean the product surface. Use only neutral solvent or clear water for cleaning.

1. Wireless product may generate shortwave radio frequencies and interfere with the normal use of other electronic devices or medical equipment.
2. Turn off the product when it's disallowed. Do not use the product in medical facilities, on airplane, at gas stations, near automatic gates, automatic fire alarm system or other automated devices.
3. Do not use the product in the vicinity of a pacemaker within a 20cm range. The radio waves may affect the normal operation of the pacemaker or other medical devices.

Illustrations

1. Connect to passive speaker
2. Line In input
3. Power cable
4. AUX input
5. Press: volume down
   Press and hold: disconnect Bluetooth (Bluetooth input)
6. Power button
   Press: input mode switch (Bluetooth - Line In - AUX)
   Press and hold: power on/off LED indicator:
   Blue (Bluetooth input)
   Green (Line In/AUX input)
7. Press: volume up
8. Connect to active speaker

Basic Operation

1. Connect speakers using speaker connecting cable from the passive speaker to active speaker.
2. Connect power cable from the active speaker to the wall outlet and turn power switch on, LED indicator will be lit and the speakers should be ready to go.
3. Connect audio source (mobile phone, tablet, etc.) to LINE/AUX input port on the rear panel of the active speaker using audio cable.
4. Press the "" button to switch between Bluetooth and Line In/AUX input modes.
5. Play music via the connected device and adjust the settings to a desired level.

Note: If pressing the "-" or "+" button continuously, LED indicator will flash continuously; When the indicator is no longer flashing, it indicates that the volume has been at the minimum or maximum level.

Bluetooth Input