Step 7 Installing The Exterior Assembly; Step 8 Installing The Interior Assembly - BRINKS BC40107 Installation Instructions Manual

6
Setting the Interior Spindle —
D
3. Remove the decorative cover (H) from the interior
assembly by pressing on the interior turn switch
with your thumbs and
separating the cover
from the body. Set
cover aside.
7
Installing the Exterior Assembly
(Right Hand door installation shown below)
A. Place the exterior assembly (C) against the exterior
face of the door while inserting its square drive
spindle through the square hole in the latch cam.
Run the power cable (D)
under the latch.
Mounting
Plate (F)
C. Orient the alignment
post of the mounting
bracket with the
corresponding post on
the exterior assembly
and press the mounting
bracket against the
interior door face.
PAGE 8
(Left Hand Door)
Interior Turn
Switch
Exterior
Assembly (C)
Alignment
Post
(continued)
4. Separate the decorative cover and set it aside with
the battery cover.
Press
B. Insert the power cable though the slot in the
mounting plate (F).
D. Insert two mounting plate
screws (BB) through the holes
in the mounting plate and
engage the screw posts of the
exterior assembly. Tighten
rmly. Check to make sure
that the exterior assembly
does not look crooked with
respect to the door.
Decorative
Cover (H)
Interior
Assembly (G)
Mounting Plate (F)
Power Cable (D)
Mounting Plate
Screws (BB) [2]