Step 11 Restoring To Factory Settings - BRINKS BC40107 Installation Instructions Manual

10
Programming (continued)
ADVANCED SETTINGS
Vacation Mode
• Start vacation mode to
(Start/End)
• Redo the following steps
Volume Control • Turn on / off door lock
• Volume is always on in
Auto-lock • Default Auto-lock Delay
Delay Timer
• Auto-lock Delay Timer
• Remember to turn the interior turn switch to vertical position to enable auto-lock mode after programming.
• The lockset will exit the programming mode and revert to the stand-by status if no input is made in 10 seconds.
• 3 Beeps means something was entered incorrectly. Please redo the step again.
11
Restoring to Factory Settings
• Rotate interior turn switch
to horizontal position.
PAGE 12
temporarily disable ALL
User Codes.
to end vacation mode and
recover User Code access.
operation volume.
the programming mode.
Timer : 5 seconds
range: 5 -90 seconds
• Remove one battery
1. This will erase all stored information.
2. The Programming Code will be restored to default 1-2-3-4-5-6.
Programming
# #
Code
(6 digits)
Programming
# #
Code
(6 digits)
Programming
#
#
Code
(6 digits)
• Press and hold # until all batteries are installed again.
• Successful reset is veri ed by a 3 second beep
followed by a short beep.
• Rotate the interior turn switch back to vertical to lock
in changes and return to auto-lock mode.
5 0 #
6 0 #
7 0 #
#
Enter New
Amount (5 - 90)