Operation At Stick Welding; Optional Accessories - Panasonic YC-400TX4 Operating Instructions Manual

6.2 Operation at stick welding

Turn on the switch of the switch
box.
Turn on the power switch on the
front panel.
Set the welding process switch
on the front panel at "Stick
welding".
Welding work starts.
Welding work ends.
Turn off the power switch on
thefront panel after 5 minutes
Turn off the switch of the switch
box.
* This machine has low no-load voltage control function. You can use this function through setting the front panel
menu P18. The system defaults to low no-load and no-load voltage output.

6.3 Optional accessories

Name
Cooling system
The LED of front panel turns on
Output voltage is generated between the output terminals.
Cooling fan rotates.
Carry out stick welding as per normal procedure.
Welding current is adjusted by the welding current adjustor on the front
panel.
The Cooling fan will stop running after welding work ends 4.5minutes
Type
This system is convenient for use in situations where
YX-09KGC2HGE cooling water (i.e. water supply) is not available for use of
water cooled torch.
Function
18