1. Blower assembly
2. Lower tube
9.
Drill the 5.6 mm (7/32 inch) diameter holes in
the lower tube using the upper tube holes as the
reference
(Figure
1. Drill the holes here.
10.
Remove the tubes from the machine and
assemble the upper and lower tubes using 3
hex-washer head bolts (#10 x 3/4 inch), 3 flat
Figure 17
3. Latch (triple bagger
shown)
18).
Figure 18
washers, and 3 locknuts (#10) as shown in
Figure
19.
Install the bolt head inside the tube to provide
minimum obstruction to flow. Ensure that the
upper and the lower ends are oriented properly
as you assemble the tubes (the parting lines
should roughly line up).
g003423
1. Lower tube
2. Upper tube
3. Flat washer
11.
With the bagger end in first, install the lower
tube onto the blower housing and secure it with
the latches.
g007028
14
Figure 19
4. Locknut (#10)
5. Hex-washer head bolt
(#10 x 3/4 inch)
g003392