Table of Contents
Advertisement
C
Electrical board feature plate
6
The equipment can be identified from:
• Packaging plate.
- It shows the identification data of the equipment.
• Frame feature plate.
- Affixed on the machine, it shows the technical and performance data of the equipment.
• Electrical board feature plate.
- Affixed on the panel from which the electrical board is accessed, it shows the electrical
data of the equipment.
If it is lost or deteriorated, request a duplicate from Technical Support.
Tampering with, removal and deterioration of the identification plates complicate any
installation, maintenance and spare part request.
1.7 Connections of the accessories
1.7.1 Circulating pump
The circulating pump must always be connected to the control unit as indicated in the wiring
diagram. The pump must be started before the chiller is started and stopped after the chiller is
stopped (recommended minimum delay: 60 seconds).
1.8 Intended use
This unit is designed to cool water (potentially added with inhibited ethylene glycol) that
circulates in a closed circuit.
The heat pump units can cool or heat the water circuit, depending on the selected operating
cycle.
The heat recovery units can act as a sub-product, heating the water that circulates in a second
closed circuit.
The hot or cold air produced by the machine, may be used for air conditioning systems or
industrial processes.
Any other use of the machine is forbidden.
Do not use flammable products near the machine.
Do not use substances that can form explosive mixtures close to the machine.
Do not use the machine where there are problems of environmental impact.
1.9 General precautions
• These units must be installed by a qualified company that at the end of the work provides the
operator with a declaration of conformity with the regulations in force and the instructions
provided by the manufacturer in this document.
• These units must comply with their intended use in line with their performance
characteristics.
• Wear suitable and accident prevention clothing and equipment during installation and/or
maintenance. The manufacturer declines any liability for non-compliance with safety and
accident prevention regulations in force.
• All unit installation, connection, start-up and shut-down operations must only be
implemented by qualified and authorised personnel.
• Comply with the laws in force in the country where the machine is installed, concerning the
use and disposal of the packaging, the products used for cleaning and maintenance and for
the management when the unit life cycle is complete.
Advertisement
Table of Contents
