Troubleshooting - Sage Nutri Juicer SJE410 User Manual

TROUBLESHOOTING

POSSIBLE PROBLEM
Machine will not work
when switched ON
Motor appears to stall
when juicing
Excess pulp building
up in the stainless steel
filter basket
12
EASY SOLUTION
• The safety locking arm may not be correctly engaged in the
vertical operating position with the locking arm located into
the two grooves on either side of the juicer cover.
• Wet pulp can build up under the juicer cover if the juicing action
is too vigorous. Try slower juicing action by pushing the food
pusher down more slowly. Follow Disassembling and Cleaning
instructions and clean the filter bowl surround, the stainless
steel filter basket and the juicer cover.
• The juicer will automatically stop operating if the motor is stalled for
more than 10 seconds. Either too much food is being processed at
one time or the pieces are not small enough. Try trimming the food
or cutting into smaller pieces of even size and processing a smaller
amount per batch. To continue juicing, reset the juicer by pressing
the ON / OFF switch on the control panel back to OFF then turn
the appliance back on by pressing ON / OFF switch to ON.
• Hard fruit and vegetables will put excess strain onto the motor
if a low speed is selected. Please refer to the juicing guide
to determine the correct speed for the fruit and vegetables
selected for juicing. Please ensure the motor is running prior
to loading the chute.
• Stop the juicing process and follow Disassembling instructions.
Remove the juicer cover, scrape off pulp, reassemble and begin
juicing again. Try alternating (soft and hard) vegetables and fruit
varieties.