Power Supply; Hold - Olympus LS-10 Instructions Manual

Power Supply

When the recorder is not being used, turn the
power off to reduce battery consumption to a
minimum. Even if the power is turned off, existing
data, mode settings, and clock settings will be
maintained.
Turning On the Power:
While the recorder's power is off, slide
the POWER/HOLD switch in the direction
indicated by the arrow.
• The display will turn on, and the power will be
turned on.
• The resume function will bring the recorder
back to the stop position in memory before
power was turned off.
• When the batteries are removed from the
recorder the resume function's stopped position
will be erased.
Turning Off the Power:
Slide the POWER/HOLD switch in the
direction indicated by the arrow for 1
second or longer.
• The display shuts off and the power will be
turned off.
• The resume function remembers the stop
position before the power is turned off.
Power save mode [Auto Power Off]
If the recorder is stopped/not used for over 10
minutes (initial setting) while the power is turned
on, the power will be turned off (☞ P.34, P.40).
• If any button is pressed prior to the battery
turning off, the elapsed time count will start
over again until this function takes effect.

HOLD

If you bring the POWER/HOLD switch to the
[HOLD] position, the current conditions will be
preserved, and all buttons will be disabled. This
feature is useful when the recorder has to be
carried in a bag or pocket.
Set the recorder to HOLD mode
Slide the POWER/HOLD switch to the
[HOLD] position.
• After [Hold] appears on the display, the
recorder is set to HOLD mode.
Exit HOLD mode
Slide the POWER/HOLD switch to the A
position.
1
11