Changing The Operating Mode; Changing The Maximum Charging Current; Property Energy Meter; External Control - LEGRAND 0 570 10 User Manual

Dynamic load management is
disabled
Dynamic load management is
enabled
Dynamic load management is
delaying or limiting the charging
Error
Note! If you have a 3-phase charging station
nected, the application shows the highest charging current and the charged energy is calculated from that
value. The actual total charged energy may be lower than calculated.
Do not change the settings marked with PRO. These settings must only be changed by a
qualified professional.

14.4. Changing the operating mode

The default setting for the charging station is "Free charging".
•
• You can change the operating mode to "Authorized" in "Settings/Charger/Operation mode".
• In the "Authorized" mode you start and stop charging with the application.

14.5. Changing the maximum charging current

• The nominal charging current depends on the charging station model.
• If your installer has set the maximum charging current to a lower value, it is due to restrictions on the
installation site.
• You can charge your vehicle at a lower current than the set maximum value. Notice that in that case it
takes longer to charge your vehicle fully.
You can set the charging current from the home screen or "Settings/ Charger/ Max. charging current".
•

14.6. Property energy meter

You can enable / disable the external meter from "Settings/Load Management/Property energy meter".

14.7. External control

You can enable / disable the override mode from "Settings/Load Management/External control (Dry con-
tact)".

14.8. Error messages

At error state, an error code appears on the screen of your mobile device. If you need to contact LEGRAND
related to faulty operation of the charging station, go first to "Settings/Charger/Error log". Save the error log
information before contacting. This information helps the technical support and maintenance to resolve the
issue.
Note! In some situations the charging station automatically returns to normal operation within approximately
5 minutes after disconnecting the charging cable.
Please see the following table for the cause and corrective actions.
(0 570 14, 0 570 16, 0 570 15, 0 570
LERAK135B_20221004
EV Charging Station
External control is disabled
External control is enabled
External control is delaying or
limiting the charging
Error
17) and all phases are con-
17 / 28