Maintenance - Schwank Swift5 Series Instructions Manual

Drive thru air curtain
Table of Contents

Advertisement

Available languages

Available languages

Maintenance

Since fan motors and other components are
maintenance free, no maintenance other than
cleaning is necessary. The level of cleaning can vary
depending on local conditions.
Undertake cleaning at least twice a year. Inlet
and exhaust grilles, impeller and elements can be
vacuum cleaned or wiped using a damp cloth.
Use a brush when vacuuming to prevent damaging
sensitive parts. Avoid the use of strong alkaline or
acidic cleaning agents.
1. Disconnect the electricity with the fully isolated
switch.
2. Allow the electrical coil to cool.
3. Determine the cause of overheating and rectify
the fault.
4. Once the overheat protector has cooled down
the unit can be started again.
Trouble shooting
If the fans are not working or do not blow properly,
check the following:
The functions and settings of the built-in
control system.
That the intake grille is not dirty.
If there is no heat, check the following:
The functions, internal sensor and settings of
the built-in control system.
For units with electrical heating, also check the
following:
Power supply to electric heater coil; check
fuses and circuit-breaker (if any).
That the overheat protection for the motors
has not been deployed.
If the fault cannot be rectified, please contact a
qualified service technician.
Packaging
Packaging materials are chosen with consideration
to environment and are therefore recyclable.
Handling of product at end of working life
This product may contain substances necessary for
functionality of product but potentially dangerous
for the environment.
The product should not be disposed mixed with
general household waste but delivered to a
designated collection point for environmental
recycling. Please contact local authority for further
details of your nearest designated collection point.
Safety
For all installations of electrically heated
products should a residual current circuit breaker
300 mA for fire protection be used.
Keep the areas around the air intake and
exhaust grilles free from possible obstructions!
The unit must not be fully or partially covered as
overheating can result in a fire risk!
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
Children of less than 3 years should be kept
away unless continuously supervised.
Children aged from 3 years and less than 8
years shall only switch on/off the appliance
provided that it has been placed or installed
in its intended normal operating position and
they have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved.
Children aged from 3 years and less than 8
years shall not plug in, regulate and clean the
appliance or perform user maintenance.
CAUTION — Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.

Advertisement

Table of Contents
loading

Table of Contents