TMT162
Endress+Hauser
Registered trademarks of Endress+Hauser Wetzer GmbH + Co. KG, Nesselwang, Germany
3
Installation
3.1
Quick installation guide
If the sensor is fixed then the unit can be fitted directly to the sensor. For remote mounting
to a wall or stand pipe, two mounting kits are available ( Fig. 4). The illuminated display
can be mounted in four different positions ( Fig. 2):
Fig. 2:
Temperature field transmitter with sensor, 4 display positions, can be plugged-in in 90° steps
A:
Sensor
1:
Cover clamp
2:
Housing cover with O-ring
3:
Display with retainer and twist protection
4:
Electronics compartment
1.
Remove the cover clamp (1).
2.
Unscrew the housing cover together with the O-ring (2).
3.
Remove the display with retainer and twist protection (3) from the electronics
compartment (4). Adjust the display with retainer in 90°-stages to the desired position
and rearrange it on the particular slot in the electronics compartment.
4.
Screw on the housing cover together with the O-ring. Mount the cover clamp.
3.2
Installation conditions
3.2.1
Dimensions
The dimensions of the device can be found in chapter 10 ' ' T echnical data' ' .
Installation
61