Maintenance; Service Position - Ariens Power Brush 36 Operator's Manual

Normal Position
Winter/Cold Weather Position
Figure 16
3. Position latches under base and lift up on
latches until they lock to secure cover.

MAINTENANCE

WARNING: Read and
understand the Safety section
before proceeding.
Your Ariens dealer can provide service and
adjustments to keep your unit operating at
peak efficiency. Contact an authorized engine
manufacturer's service center for engine
service.

SERVICE POSITION

WARNING: AVOID INJURY.
Before rotating unit, close fuel
valve and drain fuel from tank
and fuel system. (Refer to
engine manual for instructions.)
Make sure unit is secure and will
not tip.
IMPORTANT: DO NOT tip unit onto brush.
Remove brush attachment if maintenance
requires tipping unit forward. Ensure unit is
secure and will not tip.
Place Unit in Service Position
1. Move unit to a flat, level surface.
2. Stop engine and wait for moving parts to
stop and for hot parts to cool.
3. Disconnect spark plug wire.
4. Remove hardware retaining left side of
belt cover.
5. Loosen, but DO NOT remove hardware
retaining right side of belt cover and
remove cover.
EN - 14