Maintenance And Care; Spare Parts And Accessories; Disposal Information - Flex DD 2G 18.0-EC LD Operating Instructions Manual

g. To stop the drill/driver, release the
trigger switch and allow the tool to come
to a complete stop.
Drilling masonry (PD 2G 18.0-EC
LD only) (see figure R)
For maximum performance, use carbide-
tipped masonry bits when drilling holes in
brick, tile, concrete, etc.
■ Maintain a speed and a pressure that allow
cutting without overheating the bit or drill.
Applying too much pressure will:
– Overheat the drill.
– Wear the bearings.
– Bend or burn bits.
– Produce off-center or irregular-shaped
holes.
■ Apply light pressure and medium speed
for best results in brick.
■ Apply additional pressure for hard
materials such as concrete.
■ When drilling holes in tile, practice on a
scrap piece to determine the best speed
and pressure. To prevent the drill bit from
skidding/ sliding, first apply two pieces of
masking tape to create an "X" shape over
the intended drilling spot.
■ Begin drilling at a very low speed to
prevent the bit from slipping off the
starting point.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
■ Regularly blow out the housing interior
and motor with dry compressed air.

Spare parts and accessories

For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
22
DD 2G 18.0-EC LD / PD 2G 18.0-EC LD

Disposal information

WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
the power cord,
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal options!