Table of Contents
Advertisement
11
Press ON/OFF to
turn off.
* When the registered weight is insuffi cient, "PC-25" is displayed. In that case, increase the
number of specimens to 25 pieces. When the stable mark is displayed, press CAL. If the register
is still insuffi cient, the display changes to show the number of specimens to be increased.
Therefore, increase the number of specimens, and press CAL again. This operation is repeated
until the registered weight becomes 1 g or more.
the registered weight is too low to measure. Numeric numbers change as follows. (Press TARE
to increase the number of specimens)
10 → 25 → 50 → 100 → 150 → 200 → 250 → 500
◆
Default setting is 10 minutes
◆
The auto power off time can be programmed between 0 (= no auto power off) to 60 minutes by
10 minutes increments according to preference.
1
When the power
is off
5
The numeric values
are displayed.
* If the power turns off before
6
* This scale might have an error within 1% margin when the specimen is
too light.
PROGRAMMING AUTO POWER OFF
2
While pressing
MODE press
ON/OFF.
6
0
60
10
50
20
40
30
Press TARE to cycle
through the time
options.
appears, the setting is not saved.
will be displayed when you press CAL if
3
Press CAL to display
.
7
Wen you have made
your selection, press
MODE to confi rm.
4
Press MODE to
confi rm
8
Setting is fi nished.
Advertisement
Table of Contents
