Table of Contents
Advertisement
1. Use on a hard fl at surface confi rming that it is level using the bubble level.
2. To prevent wind from affecting measurement, close cover.
3. Clean using mild detergent. Chemical should not be used.
4. Always use the provided Gem cup.
5. Wait about fi ve minutes after turning the power on when calibrating.
6. When the display shows a big difference from the test weight after calibration, repeat the
calibration several times.
7. Press TARE if the display doesn't read zero when you remove the object.
8. This scale can be affected by wind, vibration, and temperature changes. If the stable mark
keeps blinking, please use in an area away from those.
9. Close the wind shield when the stable mark isn't displayed.
1 Wind sheild (cover)
2 Hinge
3 Gem cup
4 LCD display (front)
5 LCD display (back, option)
6 Test weight
7 Open button
8 Lo battery mark
2
IMPORTANT
NAMES OF PART
9 Stable mark
0 Minus sign
q Calibration mark
w Weighing modes
e ON/OFF button
r TARE button
t CALIBRATION button
y MODE button
s
u AC adaptor inlet
i Adjustable feet
o Battery compartment
p USB port (option)
a Level
s AC adapter (option)
d USB cable (option)
Advertisement
Table of Contents
