IKEA DIRIGERA Manual page 5

Ring light softly pulsing white
This is shown once your hub has finished starting up. You can
now follow the instructions in the app to connect your hub.
Centre light constant white
Shown when the hub is connected to the internet and
everything is OK.
Centre light double-blinking white
Shown when the hub is disconnected from the internet. You
can continue to control your devices through the app and your
home WiFi network.
Ring light – spinning white
When your hub is updating or busy processing a large
amount of information.
Rebooting your hub
Disconnect and reconnect the power to your hub to reboot it.
The ring light fills to symbolise loading while starting up. This
will not delete information on your hub.
Factory resetting
Push a pin into the pinhole on the underside of the hub until
the status lights turn off. The centre light will then blink red 4
times when the hub is ready. Note – this deletes all previous
hub information.
Adding IKEA Home smart to your hub
Follow the instructions in the app to add "Works with IKEA Home smart"
devices to the hub.
Care instructions
Unplug the power supply unit from the power source before cleaning
and when the hub is not in use.
To clean the hub and the power supply unit, wipe with a soft cloth
moistened with a small amount of mild cleaning agent. Use another soft,
dry cloth to wipe dry.
Never submerge the power supply unit or hub in water.
Never use abrasive cleaners or chemical solvents as this can damage the
products.
5