Table of Contents
Advertisement
Figure 8
1. Height-of-cut rod
2. Height-of-cut collar
6.
Align the height-of-cut collar to the desired
height-of-cut holes on the height of cut rod
(Figure 8
and
Figure
7.
Secure the adjustment with the clevis pin and
hairpin cotter.
Note:
Position the head of the clevis pin toward
the front of the deck, if possible.
Note:
When using 25 mm (1 inch), 38 mm
(1-1/2 inch), or occasionally 51 mm (2 inch)
height of cut, move the skids and roller to the
highest holes.
Figure 9
3. Clevis pin and hairpin
cotter
9).
decal108-1986
Adjusting the Rollers
Note:
If the cutting unit is to be used in the 25 or 38
mm (1 or 1-1/2 inch) height-of-cut setting, the cutting
unit rollers must be repositioned in the top bracket
holes.
1.
To adjust the front rollers, remove the screw and
nut securing the roller shaft to the deck bracket
(Figure
10).
g012231
1. Roller
2.
Slide the shaft out of the lower bracket holes,
align the roller with the top holes, and install the
shaft.
3.
Install the screw and nut to secure the
assemblies.
4.
To adjust the rear (internal) rollers, refer to
Figure
11.
1. Internal rollers
12
Figure 10
2. Roller shaft
Figure 11
g004487
g012332
Advertisement
Table of Contents
