Setup - Toro Groundsmaster 3320-D Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Parts Catalog
WARNING
If you leave the key in the ignition switch,
someone could accidentally start the engine
and seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
switch when the PTO shaft is not connected
to the gearbox on the cutting unit.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Description
Pivot pin assembly
Cotter pin
Lift arm, right
Lift arm, left
Thrust washer-nylon
Clevis pin
Hairpin cotter—small
Height of cut collar
Clevis pin
Hairpin cotter—large
Bolt (1/2 x 3/4 inch)
Washer
No parts required
No parts required
No parts required
Qty.
2
2
1
1
4
4
2
2
2
2
2
2
–
–
–
Qty.
1 Review the material and save in an appropriate place
1 Use to reference part numbers
7
Use
Install the lift arms to the traction unit.
Connect the lift arms to the cutting unit.
Replace the traction unit PTO shaft
(cutting unit model 30366 only).
Connect the PTO shaft to the cutting
unit gearbox.
Grease the machine.
Use