Changing The Door Seal Heater Setting - Miele KFNF 9959 iDE Operating And Installation Instructions

Selecting additional settings
Changing the door seal heater
setting 
If condensation builds up on the door
seal for the refrigerator section doors,
this can be eliminated by selecting the
highest door seal heater setting ( ).
The factory default is   (middle set-
ting).
Condensation will not usually form at
an average ambient temperature and
humidity.
If condensation should form on the
door seal at higher air humidity and a
lower ambient temperature, set the
door seal heater temperature to the
highest level.
 Touch the On/Off sensor for the Su-
perFreeze function for approx. 5 sec-
onds.
The indicator light  in the right-hand
side of the display will light up at this
time and after approx. 5 seconds
flash in the bottom (freezer section)
temperature display.
in the display. You are now in Settings
mode.
66
will
S
MENU will light up
 Touch one of the sensors for setting
the temperature in the freezer section
repeatedly until  flashes in the bot-
tom temperature display.
 Touch the Super sensor again.
The last selected setting lights up in the
display.
 You can alter the heater level by
touching the sensors for setting the
temperature in the freezer section:
-  :
Middle heater setting (in the event of
slight condensation on door seal)
-  :
Highest heater setting (in the event of
heavy condensation on the door seal)
-  :
Heater is deactivated.