Eastwood Elite QST-30 Instructions Manual page 4

SAFETY INFORMATION
• Check the manufacturer's maximum pressure rating for air tools and accessories. Compressor outlet pressure must be regulated to
never exceed the maximum pressure rating of the tool. Relieve all pressure through the hose before attaching or removing accessories.
• Do not weld, drill or modify the air tank of this compressor. Welding or modifications on the air compressor tank can severely impair
tank strength and cause an extremely hazardous condition.
• Do not adjust the Pressure Relief Valve for any reason. The Pressure Relief Valve has been pre-set at the factory for the maximum
safe pressure of this unit. Personal injury and/or property damage may result if the relief valve is tampered with.
• Use only hose, pipe and fittings rated for compressed air distribution lines. Do not use plastic or PVC pipes.
• Verify the oil drain valve is completely closed before operation. Failure to close the oil drain valve may result in pressure causing the
moisture drain system to burst.
• To provide proper ventilation for cooling and prevent overheating, the compressor must be kept a minimum of 12 inches (31 cm)
from the nearest wall, in a well–ventilated area.
• The Eastwood Elite QST 30/60 Compressor is mounted on Casters and can vibrate or move slightly during operation.
Always lock Casters before running.
• Fluids drained from the Moisture Drain Bottle are hazardous materials and should be disposed of in compliance with local regulations.
4
BURST HAZARD!
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com