Safety Information - Eastwood Elite QST-30 Instructions Manual

Scroll compressor
Hide thumbs Also See for Elite QST-30:
Table of Contents

Advertisement

SAFETY INFORMATION

READ INSTRUCTIONS
• Thoroughly read and understand these product instructions before using the Compressor.
• Keep these product instructions for future reference.
• Never spray flammable liquids in a confined area. It is normal for the motor and pressure switch to produce sparks while operating.
If sparks come into contact with vapors from gasoline or other solvents, they may ignite, causing fire or explosion. Always operate
the compressor in a well-ventilated area. Do not smoke while spraying. Do not spray where sparks or flame are present.
Keep compressor a minimum of 20 feet from spray area.
• Never allow the compressor to operate unattended. Always move power switch to the "OFF" position before leaving the work area.
• Never use an electric air compressor outdoors when it is raining or on a wet surface, as it may cause an electric shock.
• Compressor must be installed by a licensed electrician.
• This unit starts automatically. ALWAYS shut the compressor off at the pressure switch, bleed all pressure from the tank, then shut off
breaker or disconnect power supply before servicing the compressor, and when the compressor is not in use.
• Never direct high-pressure airstream to exposed flesh.
• This compressor must be located only on a flat, level and secure surface. Do not locate the compressor on an elevated platform,
table, bench, roof or other non-secure location.
• Before performing any service, turn Power Switch to the "OFF" position, shut off breaker or disconnect power supply and release
pressure from Tank until Gauge indicates 0 PSI.
• The Oil Tank may be under pressure. Opening the Drain Valve or removing the Fill Plug under pressure can cause oil to be blown out
at high velocity. Move Power Switch to the "OFF" position. Release pressure from the Tank until Tank Pressure Gauge indicates 0 PSI.
Disconnect Compressor from power supply. Always wear appropriate eye protection.
• COMPONENTS ARE HOT! Significant heat is generated during operation. Allow to cool a minimum of 1 hour after last use before
servicing to avoid burns.
• Air, moisture and debris can be ejected at high velocity while using this equipment. Always wear ANSI Z87 approved eye protection
when operating this compressor and associated equipment.
• Air discharged from this compressor is not intended for and should never be used as supply air for human consumption.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIRE OR EXPLOSION HAZARD!
FIRE HAZARD!
ELECTRICAL SHOCK HAZARD!
INJURY HAZARD!
BURN HAZARD!
EYE INJURY HAZARD!
HEALTH HAZARD!
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite qst-6063600

Table of Contents