Meters And Lighting; Cueing Controls - Numark MATRIX3 Operating Instructions Manual

CONTROLS

3. Meters and Lighting

"Master Level" (Master Level Meter)
This meter displays the stereo output levels of the master signal. The display ranges from -40dB to
+10dB.
Dual BNC Style Light Connectors
Two BNC style lights can be connected simultaneously to these 12V receptacles.

4. Cueing Controls

"Volume" (Headphone Level)
This rotary control adjusts the levels of the headphones connected to the front panel input. Turning the
knob completely to the right increases the level and turning the knob completely to the left decreases the
level.
"Split/Blend" (Master/Split Style Headphone Cueing Switch)
The split cueing mode is engaged by depressing the button into the low position. The split mode means
that any selected source (CH-1 to CH-3 and Mic) will be sent to the left channel of the headphones and
the master output is sent to the right. If the blend cueing mode is engaged (the button will be in the up
position) then the cued or master source (dependent on "Mix") will be heard in both the left and right
channels of the headphones.
"Mix" (Master/Cue Blend Control)
This control blends between the cued source(s) and the master output. At the center position an even mix
of both the master output and the cued source are monitored. Turning the knob completely to the right
selects only the master output and turning the knob completely to the left monitors only the cued
source(s.)
"Headphones" (Quarter Inch and Eighth Inch Headphone Output Terminals)
Two headphones can be connected simultaneously to these Quarter Inch and Eighth Inch output
terminals. The Volume should always be set at its lowest setting while connecting and disconnecting
headphones to prevent damage to headphones and/or your hearing.
"PFL" (CH-1, CH-2, CH-3 and Mic Cue Buttons)
CH-1, CH-2, CH-3 and the Microphone can be sent to the headphones one at a time or simultaneously for
cueing. When depressed, the PFL button illuminates yellow indicating that the source is being cued. Use
the "Mix" control to get a balance of the cued PFL source(s) and the master output in the headphones.
PAGE 9 METERS+ LIGHTING, CUEING CONTROLS