Viavi NSC-100 Quick Card User Manual page 3

Network & Service Companion (NSC-100/200)
QUICK CARD
C O N F I G U R E P R O F I L E ( C o n t i n u e d )
Enter a Profile Name.
4.
Slide controls to the right
5.
Run Ping Test and Run Ookla Speedtest.
Swipe up screen to view Interface
6.
Configuration and Data Interface settings.
Configure Interface Type as follows:
7.
Port
1Gig Electrical
2.5Gig Electrical
5Gig Electrical
10Gig Electrical
1Gig Optical
10Gig Optical
Configure other interface settings to match the
8.
port under test on your network equipment:
► Autonegotiation: On or Off
(Typically on)
► Interface Rate: 10M, 100M, 1G, 2.5G,
5g, or 10G (Only needed if
Autonegotation is Off)
If a Static IP Address if required, change the
9.
Address Type to "Static" and enter IPv4
Address, Gateway, and Subnet Mask.
Swipe up screen to view Ookla Configuration
10.
settings.
Enter pass/fail threshold for the Speedtest
11.
►
Upload Threshold (Mbps)
► Download Threshold (Mbps).
Press
12.
Tap Select and select the location for your test.
13.
Network & Service Companion
to enable
Interface Type
RJ45
SFP
SFP
SFP
SFP
SFP
to initiate the test.
Figure 8: Profile Editor
Figure 10: Ookla Configuration
VIAVI//Public
Figure 9: Interface Configuration
Figure 11: Select a Location
3