Makita DVC867L Instruction Manual page 18

polyethylene bag is easier to empty the tank without letting your hands
dirty.
Spread the polyethylene bag in the tank. Insert it between the holder
plate and the tank, and pull it to the hose inlet.
► Fig.12:
1. Holder plate 2. Polyethylene bag
Spread the bag around the top of the tank so that the prefilter edge
can catch and hold the bag securely. ► Fig.13:
NOTE: A polyethylene bag available on the market can be used.
0.04 mm or thicker one is recommended.
NOTE: Too much dust will tear the bag easily, so do not collect the
dust more than the half of the bag capacity.
Emptying the polyethylene bag
WARNING:
Always make sure that the
cleaner is switched off and the battery cartridge
is removed before emptying the polyethylene
bag. Failure to do so may cause an electric shock
and serious personal injury.
CAUTION:
Do not apply a great impact on the
tank. Applying a great impact may cause deformation
and damage to the parts.
CAUTION:
Empty the tank at least once a day
although this depends on picked-up dust volume
in the tank. Or, the suction force will weaken and the
motor may be broken.
CAUTION:
Do not grab the hook when
emptying the tank. Grabbing the hook may cause the
hook to break.
Unhook and lift up the tank cover.
Shake off the dust from the prefilter and then take the polyethylene
bag out of the tank. ► Fig.14
NOTE: Take the polyethylene bag carefully out of the tank so that the
polyethylene bag cannot be caught and torn by the protrusion inside
the tank when emptying it.
NOTE: Empty the polyethylene bag before it becomes full. Too much
dust in the tank may cause the polyethylene bag to be torn.
Installing the tool box
1. Release the lock of the battery cover, and open the battery
cover.
2. Set the rails on the tool box along the grooves on the
housing.
Close the battery cover and apply the lock. ► Fig.15
3.
The tool box is convenient for carrying batteries, pipe, or cuffs. ►
Fig.16
NOTICE:
Never force the hose for bending or stamp it. Never
move the cleaner by a hose. Forcing, stamping and pulling the hose
may cause a breakage or deformation of the hose.
NOTICE:
When picking up large wastes such as planer carvings,
concrete dusts or similar other than small wastes, use the 38 mm
inner diameter hose (optional accessory). Using the 28 mm inner
1. Prefilter
18 ENGLISH
diameter hose (optional accessory)
may cause a hose stuffing and
damage.
Insert the hose onto the mounting
port of the tank and turn it clockwise
until it locks.
► Fig.17
Connecting the
attachment with lock
function
Optional accessory
Insert the attachment into the suction
inlet until it clicks. To remove, pull the
attachment while pushing the release
button.
► Fig.18:
1. Suction inlet with lock
function 2. Release
button 3. Attachment with
lock function
NOTE: The attachment with lock
function is available when using the
suction inlet with lock function.
► Fig.19:
1. Attachment with lock
function 2. Suction inlet
with lock function 3.
Suction inlet without lock
function
Adjusting the length of
the slidetype extension
wand
Optional accessory
With pressing the slide button, adjust
the wand length.
The length is locked when releasing
the slide button. ► Fig.20:
Slide button
WIRELESS
ACTIVATION
FUNCTION
What you can do with
the wireless activation
function
The wireless activation function
enables clean and comfortable
operation. By connecting a supported
tool to the cleaner, you can run the
cleaner automatically along with the
switch operation of the tool. ► Fig.21
1.